This heater must not be installed where curtains or other combustible materials could come into contact with it. For information on gas type, see data plate on the appliance.ģ. The installation must conform with local codes or, in absence of local codes, the National Fuel Gas Code, ANSI Z223.1 or the Canadian Installation Code, CAN/CGA-B149.Ģ. Refer to local gas authority for confirmation of gas type if you are in doubt.īefore using this product, please read this manual carefully to insure proper use of product.ġ. Before installing a heater, check the label for the correct gas type (see label on heater). (DO NOT INSTALL DAMAGED HEATER.) If heater is damaged, contact your supplier for advise. IMPORTANT POINTS / USAGE AND INSTALLATION MUSTS ALTERATION OF THE ORIGINAL DESIGN INSTALLED OTHER THAN AS SHOWN IN THESE INSTRUCTIONS OR USED WITH A TYPE OF GAS NOT SHOWN ON THE RATING PLATE, IS THE RESPONSIBILITY OF THE PERSON AND COMPANY MARKING THE CHANGE. THIS SERIES HEATER IS DESIGN CERTIFIED BY CSA INTERNATIONAL AS A DIRECT VENT WALL FURNACE AND MUST BE INSTALLED ACCORDING TO THESE INSTRUCTIONS. The minimum inlet gas supply pressure is for the purposes of input adjustment. *There are two 1/8" NPT test points for measuring differential pressure, one is located on the modulating gas valve, the other is located on the burner manifold. See conversion for setting gas pressures. Rinnai is continually updating and improving products therefore specifications are subject to change without prior notice. Local and state codes must be adhered to prior to installation. Power Outage Safety Device: This safety device cuts off gas passage and stops operation. If fuse blows all indicator lamps will be “OFF”. Design to shut unit down in case of overcurrent. Overcurrent Prevention Device: This is a 3 amp. Indicator lamps “68”, “FILTER” and “ON” will flash. If the fusible link cuts the unit off, a service call by an authorized person is required to replace the link. Two Fusible Links: Backs up the overheat switch. Indicator lamp “68” “ON” and the “FILTER” indicator lamp flash when overheat switch is activated. This is normally caused by an obstruction in front of the louvers, or a blocked fan filter. Overheat Switch: This device automatically cuts the gas off if the heater exceeds a predetermined temperature. This prevents raw gas from being released. If burner fails to ignite, indicator lamp “60” flashes. Display lamps “LOW”, “60”, and “64” will activate if this happens.įlame Failure Device: Activated when burner flame fails, indicator lamp “ON” flashes. Spark Safety Device: Automatically shuts unit down when there is an abnormal spark at time of ignition. Modern Design Minimizes Floor Space Requirements Warm Air Outlet at Floor Level (Keeps Your Feet Warm) Ĭomfortable Room Temperature Control and Display ĪDDITIONAL CUSTOMER OPERATING INFORMATION. IMPORTANT POINTS / USAGE AND INSTALLATION MUSTS. INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER, SERVICE AGENCY OR THE GAS SUPPLIER.įEATURES OF THE RHFE-431FA UNITS. IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE OR MAINTENANCE CAN CAUSE PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE, REFER TO THE OWNER'S INFORMATION MANUAL PROVIDED WITH THIS APPLIANCE.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |